![]() ![]() ![]() Remove the screws that are holding the starter assembly in place.Take the starter cord out of the pull handle.Unsticking a pull cord on a lawn mower is not a difficult task and can be done in a few steps: The pull cord can lock up if the mower's wheels are stuck.A mower's blade can cause the pull cord to lock up if it hits an object while running.A dirty air filter can restrict airflow to the engine, causing the pull cord to lock up.The pull cord can lock up if the mower's engine isn't getting enough oil.Some reasons your Toro lawn mower pull cord may lock up are the following: Then, turn the adjusting screws until the engine runs at the correct speed. To adjust the carburetor, you will need to remove the air filter and loosen the screws that hold the carburetor in place. A rich mixture can make the engine run cooler and can cause the engine to stall. The engine can run lean or rich if the carburetor is not working properly.Ī lean mixture will cause the engine to run hot and damage the engine. The carburetor mixes air and fuel before it flows into the engine. One other reason why your Toro riding mower is not moving forward or in reverse is that your carburetor may be clogged. If the level is too high, you may need to drain some fluid to bring it down to the correct level. If the fluid level is too low, you should add hydraulic fluid. ![]() The fluid level should be between the minimum and maximum marks on the dipstick indicator. You can check the fluid level by looking at the indicator or dipstick. Insert the dipstick back into the transmission and withdraw it. To check the fluid, remove the dipstick from the transmission and wipe it off with a clean cloth. Hydraulic Fluid May Be LowĪnother reason is that the hydraulic fluid of your mower may be low. Then, reattach the deck, and you should be good to go. Once the pulley or gear is repaired or replaced, reattach it to the transmission and screw it in place. However, if the gear is worn, you can try sanding it down with fine sandpaper until it is smooth again. If the gear is damaged, you'll need to replace it. Then, inspect the gear for any sign of damage. You should check the transmission pulleys for wear and damage.įirst, remove the deck and unscrew the pulley or gear from the transmission. If these pulleys are damaged, they can cause the mower to move erratically or not at all. They help to transfer power from the engine to the wheels. The transmission pulleys are located under the mower deck. Transmission Pulleys Damaged Or Worn OutĪnother reason your Toro riding mower might not be moving forward or in reverse is that the transmission pulleys are damaged or worn out. Once the pulleys are removed, you can thread the new belt through and reassemble the mower. To replace it, you must remove the deck and unscrew the pulleys. If the drive belt is broken and overstretched, it will need to be replaced. Over time, the drive belt can become worn or stretched, causing it to slip or break. The drive belt is a rubber belt that connects the engine to the transmission. If your Toro riding mower is not moving forward or in reverse, it may be due to a problem with the drive belt. But what do you do when your mower won't move forward or backward ? There are a few reasons why this occurs, including the following: Drive Belt Broken Or Stretched Reasons Your Toro Riding Mower Won't Move Forward Or BackwardĪ riding lawn mower can be a big time-saver when cutting your lawn. This article will also explore other relevant parts of your mower, like the pull cord and the carburetor. To learn more, stay put and keep reading, as these listed points will be discussed in-depth. To fix your Toro mower, you may need a professional to check the transmission pulleys and gears to identify the problem and possible solutions. The hydraulic fluid may be low or contaminated.The transmission pulleys or gears may be damaged or worn out.The drive belt may be broken or stretched, causing the transmission pulleys to slip.There are a few possible reasons why your Toro riding mower might not be moving forward or in reverse: This is a common issue for many brands of riding mowers, including Toro, but why does it occur, and how can you fix it? We’ve done our research, and here’s what we found. A Toro riding mower that won't move forward or in reverse can be a frustrating and potentially costly problem. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |